TR 214 Liquid Mold Release 脱模剂

Liquid mold release is recommended for use on fully cured, well conditioned molds only. It is not recommended on new or reconditioned molds until at least eight or ten parts have been pulled using paste wax. It should not be used as a final coat over paste wax as the high solvent content is provided to remove wax and wax build up. Rapid settling of liquid waxes requires shaking well immediately before and during eacch use.

Directions: On clean surface apply a small amount with brush, spray, or cloth. Be sure entire area is covered. Allow to dry and brush or wipe off. Excellent on, nonskid, grained, or sand type finsihes. Repaet as required.